Search results for: '24 slide bear unpinned key cylind'

This Institutional Mortise Hinge With Security Stud 604 FMCS is made from investment cast 304 stainless steel.  Hinge is 4 1/2″ X 4 1/2″ X 3/16″ thick, with hospital tip and maintenance-free bearing assemblies.

This maximum security locking device is designed with security foremost in mind. The door operator is contained in a securely baffled, continuous or individual, compact housing. Surface mounted locking column at rear of opening is of seamless, one piece construction to resist tampering. Provides for positive two point locking in both the open and closed position with automatic mechanical deadlock.

The Airteq 5060 is a high security latch with key operated deadlock for use on cell, corridor, dayroom and other large doors where slam-locking and the security of a deadlock is required.

The Airteq Deadlock 5060K is a high security latch with key operated deadlock for use on cell, corridor, dayroom and other large doors where the convenience of a latch with knob operation is preferred and the ability to deadlock is required.

The High Security Food Pass and Anti-Splash Box System was designed by On the Gate for use in access-sensitive areas on swinging and sliding doors.

The Motorlock 9424 provides for electric or manual locking / unlocking of swinging doors. It can be operated from a remote location or by key at the door.

The Airteq 5017 is a medium security latch for use on food pass, observation, gun locker, wicket and other small swinging doors where slam-locking is preferred and deadlocking is not required.

The 9900 provides for pneumatic or manual locking / unlocking of swinging doors. It can be operated from a remote location or by key at the door. For additional security, it is recommended that the 9900 lock be used with an Airteq high security door position sensor. An automatic door closer may also be used.

The 95XX series retrofit kit allows for the replacement of existing locks from any manufacturer with a high security Airteq motorized (9524) or pneumatic (9500) lock. The kit consists of a locktube which is welded to the face of the existing frame and a strike/pull plate which is bolted or welded to the face of the door.