Search results for: '304 0000 24 stepper motor'

The 95XX series retrofit kit allows for the replacement of existing locks from any manufacturer with a high security Airteq motorized (9524) or pneumatic (9500) lock. The kit consists of a locktube which is welded to the face of the existing frame and a strike/pull plate which is bolted or welded to the face of the door. No frame or door modification is required other than filling of the existing hardware prep. This is a great low-cost option for replacing obsolete or sub-standard locks, or for adding remote unlocking capability to an existing door with only manual operation.

The High Security Food Pass and Anti-Splash Box System was designed by On the Gate for use in access-sensitive areas on swinging and sliding doors.

The 650 door stop is designed for use with door hardware with up to a 2 1/4" projection

The Pull Handle 612 is cast in bronze with a clear coated satin finish of approximately US32D . Overall length is 8 3/4″.

Cast in bronze with a clear coated satin finish of approximately US32D. The size of the face plate is 4″ X 5″ X 1/8″.

This maximum security locking device is designed with security foremost in mind. The door operator is contained in a securely baffled, continuous or individual, compact housing. Surface mounted locking column at rear of opening is of seamless, one piece construction to resist tampering. Provides for positive two point locking in both the open and closed position with automatic mechanical deadlock.

This Prison Hinge 603 can be used for many prison applications, including access panels and weapons lockers. Hinge is 3″ X 4″ X .210″ thick steel with a fully welded pin.

This Food Pass Hinge with Stop 603FP surface mounted hinge is used on food pass doors.